XtarpsⓇ Simple & Quick Pool Cover - Debris Plus Sun Block Cover,  No Tool, No Drilling, No Construction (Black Color)

This simple and quick pool cover is a weight holding system by putting weight on top of cover around the pool to hold down cover.  No tool, no drilling needed and no construction are needed. 

* Block Sun & Stop Debris and Leaves - The mesh pool opening will block about 90% of sun shine, which will greatly slow down algae growing and keep your water clear.  Also the mesh will let water pass through easily while keep debris and leaves from entering your pool, keeping your pool clean.

* Heavy Duty & Reusable - This pool cover is made from heavy duty gauge (7 oz per square yard) polyester mesh fabric with reinforced webbing on all 4 sides.  The fabric is UV resistant, chemical resistant and tear resistant, can be reused for years.

* Easy Setup - This pool cover can be set up by one person only, no tools needed, no drilling required, no more construction. (see setup instruction below)

* Pool Cover Size Selection - Pool cover size should be at least 1 feet bigger than the pool on each side.  If your pool is 12x20 feet, then you should get at least 14x22 cover, and so on..

* What is in the package:  1 unit of pool cover and matching quantity of weight bags.  The weigh bag holds 1 unit of the standard 8x8x16 concrete block (The concrete block is NOT included and you can purchase from local home improvement store.). 

Instruction:

Setup Weight Block:

1.  Open the weight bag and put 8x8x16 size concrete block inside the weight bag (concrete block is not included and can be purchased from local home improvement store such as Homedepot, Lowes, etc.)

2.  Each concrete block is about 35 LB weight.

3.  Carry the weight bag and disperse them around the pool, 10-15 ft apart.

Setup Pool Cover

1. Open the cover and roll it up as pool wide.

2.  Start with one end of the pool, unroll couple of feet of the cover and put first 2 weight block on top of each cover corner.

3.  Keep unrolling the cover on top of the pool and continues put the weight on top of cover sides around every 10-15 ft.

4.  After the pool is covered, stretch the pool cover to make it flat.

5.  Do NOT step over the pool cover.